Power Down; Input Switch - SPL Performer s1200 Schnellstartanleitung

Performer s1200 – Quickstart
Power up
10
Turn down the volume of the connected preamplifier.
Switch on mains switch on the rear of the Performer s1200 (On = I).
11
Power LED lights up.
Standby
The Standby function requires an AMP CTL connection to an SPL device
12
supporting an AMP CTL output or a 12V trigger controller.
In standby the Power LED is dimly lit.

Power down

13
Turn down the volume of the connected preamplifier.
14
Switch off mains switch on the back of the Performer s1200 (Off = O).
Power LED no longer lights up.
Gain trim
You can trim the amplification gain with the trim switches on the rear of the unit
15
to adjust playback levels in multi-speaker setups.

Input switch

You can switch the input source between XLR or RCA. You can not use both at
16
the same time.
4
PROTECT PWR TEMP
VOLTAiR
Performer
s
120V DC Audio Rail
11 12 14
Performer s1200 – Quickstart
EN
DE
Stereo Power Amplifier
Power LED
5