Installation Location - Signat FURY 400 2x65 W Bedienungsanleitung

2.1 Note
Before commencing the installation work, please first plan the complete installation, taking
into account the cable layout and the installation of the equipment.
We recommend handing over the installation work to a specialist installer. Evidence of
technically correct installation and connection of the equipment is a pre-condition for the
provision of guarantee services by SIGNAT, should a defect occur.
WARNING:
Disconnect the negative (-) battery cable before mounting the amplifier or before making any
connections
2.2

Installation location

Choose a mounting location for your amplifier. Find a location on a flat surface away from
heat and moisture; please ensure that there is sufficient room for movement when laying the
cable connections and for operating and inspecting the adjustment devices and control
switches. Be sure the mounting location and the drilling of pilot holes for mounting will not
present a hazard to any wires, control cables, fuel lines, fuel tanks, hydraulic lines, or other
vehicle systems or components (Attention: components of this type may also be hidden in
double-walled linings!).
Common mounting locations are under the front passenger seat, or in the trunk area. Choose
a location with unimpaired air circulation. The amplifier will dissipate heat more efficiently if
mounted vertically.
2.3 Mounting
The amplifier must be professionally attached in the interest of safety. The chosen location
must be suitable for taking the screws and offer sufficient support.
Use the enclosed screws. Place the amplifier at the mounting location, and mark the positions
of the holes with a marker, pen or pencil. Using a 2.5mm bit, carefully drill the mounting holes
in the marked positions.
Check carefully before drilling any pilot holes.
Use the supplied mounting screws to securely fasten the amplifier to the mounting surface.
All manuals and user guides at all-guides.com
2 Installation
5