Klarstein VINSIDER 24 BUILT-IN UNO Bedienungsanleitung Seite 23

Hints on built-in Wine Cellars
• All units with ventilation slots on the front are suitable for installation, but must not
be installed in completely closed housings.
• Built-in units suck air from the right side of the ventilation frame (some models also
from the rear) and let it out through the front ventilation frame.
• Like many electrical appliances, the wine refrigerator has many sensitive parts
that can be damaged by power failure or lightning. Your connections should
therefore be equipped with overvoltage protection.
• If you install the unit in a frame with a door, there must be a ventilation opening at
the bottom of the door. In hot climates, slots of at least 40mm x 200mm must also
be provided at the top of the back or at the top of both sides of the enclosure to
allow cool air to enter. Space of at least 30 mm must be left to the rear wall of the
frame. The ventilation slot should not be located on a side where another device,
such as an oven, is already installed.
EN
23