Wall Mounting - FS IPC201-2M-B Schnellstartanleitung

Wall Mounting

1. Locate the positions of the holes by pasting installation position map on the wall
and aligning the cross center to the hole in the wall.
2. Drill holes with a diameter of 6 - 6.5 mm and the depth of 30 mm in the marked
locations.
3. Knock the plastic rivets of self-tapping screws into the guide holes and ensure that
they are tightened up.
Locknut
4. Screw the locknut to loosen the universal joint, then secure the camera to the wall
by leading the self-tapping screws through the guide holes in the base and x them to
the wall by using a screwdriver.
EN 7