Operation In A Vehicle; Connecting To A Voltage Supply - ULTIMATE SPEED USSW 300 B2 Originalbetriebsanleitung

A gap of 50 cm must be
„
maintained behind the
ventilation slots of the
fan 14 .
There are holes
„
plastic base of the car power
inverter 1 so that it can
mounted securely in a vehicle.
Using suitable screws, the car
power inverter
securely mounted. When doing
this make sure you maintain
the space for air circulation as
stated above.
Due to vehicle-specific factors,
„
it is not possible to include fit-
tings which fit all situations.
If you are unsure, contact your
„
motor vehicle garage.
z Operation in a vehicle
If you are operating the car power
inverter 1 in a vehicle, make
sure that the installation does not
impair your driving. You should
therefore always lay the cable so
that it does not touch any moving
15 in the
1 can be
Instructions for operation
parts inside the vehicle and does
not obstruct your vision.
Note:
The car power inverter
also be operated with the engine
switched off. But please note that
the car power inverter
possibly not work when you are
starting up the engine.
z Connecting to a voltage
supply
Attention!
Before connecting the car power
inverter 1 to a voltage supply,
make sure that the On/Off switch
4
of the device is in the "0" (OFF)
position. You can connect the car
1
power inverter
for the electrical system using the
12 V plug 12 or clamp the cables
with 10 and 11 connecting clamps
directly to a car battery.
GB/IE/NI/CY/MT
1 can
1 may
to a 12 V socket
19