Zepter medolight BluDoc Bedienungsanleitung Seite 4

EN BG CS DE FR HR HU IT
3. Setting the radiation time
By pressing the „T" button (TIME) you can select the radiation time in sequ-
ences 5 min 10 min
led by the icon being backlit with green light .
4. Radiation
After selecting the radiating program and time, briefly press the ON/OFF
button . LED matrix is now lit . Direct the light on the place to be radiated .
5. Pause
At any time, briefly pressing the ON/OFF button will turn off the LED matrix .
Selection of a given program (P1-P5) and the time remaining to the end of
radiation (5-25 min) are lit up .
If within 1 minute you briefly press the ON/OFF button again, radiating will
be resumed . If within 1 minute you do not press the ON/OFF button again,
the device will go into the sleep mode . During the pause it is possible to
change the program and the radiation time by pressing the „P" (PROGRAM)
or „T" (TIME) buttons (sections 2 and 3) . You can end the radiation procedu-
re by pressing the ON/OFF button for 2 seconds .
6. Radiation end
Radiating will automatically end after the selected time and the device will
go into the sleep mode . Radiating can be finished by pressing the ON/OFF
button for 2 seconds at any moment . After a short beep, the device will go
into the sleep mode .
„P" button
(PROGRAM)
„T" button
(TIME)
PL RO RU SK SR UA AR
15 min 20 min
4
25 min 5 min... signal-
programs
P1–P5
„ON/OFF"
button
radiation
time
5–25 min