Preparation And Operation - Wiha zai Hause DHT0003 Bedienungsanleitung

Use
Backside LED (Fig. 1/
0–24%
25–49%
50–74%
75–99%
100%
NOTE: During the charging process, the heating of the tool housing is normal. The tool does not work du-
ring charging. If there is no response when the ON/OFF switch is pressed during charging, it is not a tool fault.
NOTE: The tool works best at normal room temperature.

6.2 Preparation and operation

1. Place the glue stick (Fig. 1/
fitted properly and only use glue sticks with a diameter of 7 mm.
2. Press the ON/OFF switch (Fig. 1/
3. Red LEDs on the back of the tool will light up to indicate that the tool is heating up.
4. After approx. 15 seconds' heating, the tool is now ready for operation. When the temperature is high
enough, LEDs will change from red to blue. The tool is ready for operation.
5. Pull the trigger lever (Fig. 1/
NOTE: If you don't pull the trigger lever, the power will turn off after 2 minutes.
6. To switch the tool off again, press the ON/OFF switch briefly just once.
NOTE: If 4 red LEDs flash, it means you need to insert a new glue stick.
09/06/21 Original instruction manual
):
7
1 blue LED strobe flash
2 blue LEDs strobe flashes
3 blue LEDs strobe flashes
4 blue LEDs strobe flashes
4 blue LEDs remain lit
) in the opening provided on the back of the tool. Check that a glue stick is
4
) for approx. 2 seconds.
2
); the glue flows out of the glue nozzle (Fig. 1/
9
).
1
EN
11