Data Transfer - Umarex Laserliner CompactCross-Laser Pro Bedienungsanleitung

Checking the vertical line
Position the device about 5 m from a wall. Fix a plumb bob with a line of
2.5 m length on the wall, making sure that the bob can swing freely. Switch
on the device and align the vertical laser to the plumb line. The precision is
within the specified tolerance if the deviation between the laser line and the
plumb line is not greater than ± 1.75 mm.
Checking the horizontal line
Position the device about 5 m from a wall
and switch on the cross laser. Mark point B on
the wall. Turn the laser cross approx. 2.5 m to
the right and mark point C. Check whether the
horizontal line from point C is level with point B
to within ± 1.75 mm. Repeat the process by turning the laser to the left.
!
Regularly check the calibration before use, after transport and after
extended periods of storage.

Data transfer

This device has digital connectivity which allows wireless data transfer
to mobile devices such as smart phones or tablets with a wireless interface.
The system prerequisites for a digital connection are specified at
http://laserliner.com/info?an=ble
This device can generate a wireless connection to devices which are compatible
with the wireless
standard IEEE 802.15.4. The wireless standard IEEE 802.15.4 is a transfer
protocol for Wireless Personal Area Networks (WPAN). The range is set to
a maximum distance of 10 m from the terminal device and greatly depends
on the ambient conditions such as the thickness and composition of walls,
sources of interference as well as the transmit / receive properties of the
terminal device.
The digital connection is activated as soon as the device is switched on as the
wireless system is designed to use very little electricity. A mobile device can link
up to the active measuring device via an app.
CompactCross-Laser Pro
B
2,5 m
C
17
EN