Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4. Housing installation
4.1 Preparation
1
Fig. 2
Fig. 3
Ø 12 mm
Ø 5 mm
Fig. 4
2
1
Ø 10 mm
Ø 7 mm
•
Undo the pre-installed captive screw on
the housing cover (2).
If necessary, an M4x20 grooved screw
can also be used here.
•
Flip open the housing cover.
•
Mount the housing onto the wall. Before
drilling holes beware of existing utilities
(gas, water, electricity).
Refer to Fig. 1 for the provided mounting
holes.
•
After the housing has been closed again,
there is the option of installing a security
seal using the pre-formed tab (1).
There are two tabs (1) on the underside
•
of the housing for the option of attaching
a cord. Doing so ensures that the hous-
ing cover is attached to the housing and
thus can't be lost.
•
To feed in the micropipe, open up the
appropriate diameter at the set break
point using a suitable tool.
•
For diameter dimensions, refer to Fig. 4.
2
Werbung
