How To Use Functions; Timer Setting - Toshiba HWS-803XWHM3-E Bedienungsanleitung

Hydro Unit
3

HOW TO USE FUNCTIONS

Timer setting

Function not available on second remote controller
First, set the current time on the remote controller.
Procedure to set the current time and day of the week
(If day/time is not set, the indication of time and day of
the week blinks.)
(1) Press the TIME
more to enable the time setting mode.
• The SETTING
(2) Set the current day of the week with the DAY
button.
• Each time the button is pressed, the
shifts cyclically pointing MO → TU → ... → SU →
MO.
(3) Set the current time with the TIME
buttons.
• If you press the buttons long, the current time can
be set in units of 10 minutes.
(4) Press the SET
7-EN
or button for 4 seconds or
segment blinks.
segment
and
button to determine the setting.
Heating or cooling operation
Performing heating or cooling operation
• Press the ZONE1, 2
or cooling operation.
The set temperature appears under
the remote controller. (When ZONE2 is provided, the
set temperature appears simultaneously under
.)
• During the heat pump operation or while the internal
heater or backup heater is energized,
displayed.
• Use the OPERATE MODE
cooling operation or heating operation.
Each time this button is pressed, heating
cooling are switched alternately.
• To stop heating or cooling, press the ZONE1, 2
button. The set temperature and
out and the heating or cooling operation stops.
Setting temperature
• Press the SELECT
and select
• Change the set temperature with the TEMP.
button.
• The ZONE2 setting temperature must be equal to or
lower than the ZONE1 setting temperature.
When room temperature control is selected with second remote
control, the set temperature will be set room temperature.
– 7 –
Owner's Manual
button to start heating
on
is
button to select
and
go
button to move
or .