AsViva EKC6 Betriebsanleitung Seite 39

ASSEMBLY
ATTACH THE FRONT WHEELS
Remove all the parts from the front axle.
1. Slide a Ø10 washe onto the front axle.
2. Slide the inner bushing onto the front axle.
3. Slide a Ø10 washer onto the front axle.
4. Slide a outer bushing (ring end first) onto the front axle.
5. Slide the front wheel onto the front axle. and keep the front wheel match with the outer bushing (4).
6. Slide a Ø10 washer onto the front axle.
7. Tight a Ø10 Locknut to the end of the front axle with a spanner.
8. Finally, clip on / snap in the hubcap.
Repeat this step for the other side.
5
6
7
8
After assembling any wheel to the axles, please check the
gap between the screw thread and the collapsible (refer to
below picture), if the gap is too big, please add two or three
washers inside the wheel, but after tightening the nut outside
the wheel, please turn the wheel by your finger to check if the
wheel can run smoothly, this is very important, because if the
wheel can run smoothly, it is ok, but if the nut press the wheel
and the wheel can't run smoothly, the motor will be broken
GAP
easily! Then you need to decrease one or two washers to
make sure the wheel can run smoothly!
Front axle
1
2
3
4
Tools required: Spanner
.
39