Assembly; Operation - Husqvarna DM 540i Bedienungsanweisung

®
Bluetooth
CAUTION:
made to this equipment not expressly
approved by HUSQVARNA may void the
FCC authorization to operate this
equipment.
Notice: This device complies with Part 15 of FCC Rules
and with Industry Canada licence-exempt RSS
standard. Operation is subject to the following two
conditions:
Introduction
WARNING:
product, read the safety chapter.
WARNING:
during assembly, disconnect the battery
from the product.
Introduction
WARNING:
safety chapter before you use the product.
To do before you operate the product
1. Read the operator's manual carefully and make sure
that you understand the instructions.
2. Do the daily maintenance. Refer to
schedule on page 17 .
3. Make sure that there is no oil on the handles.
4. Make sure that the work area is clean and bright.
5. Use personal protective equipment. Refer to
Personal protective equipment on page 12 .
6. Make sure that the product is installed correctly. The
drill bit must be attached correctly.
7. Install and fully tighten the auxiliary handle only
when you use the product handheld. Refer to
the auxiliary handle on page 15 .
8. Use a dust extractor when you do dry drill
operations. Refer to
drilling on page 15 .
14
Changes or modifications
Before you assemble the
To prevent accidental start
Read and understand the
Maintenance
To prepare the product for dry
• This device may not cause harmful interference
• This device must accept any interference received,
including interference that cause undesired

operation.

Le présent appareil est conforme aux CNR d'Industrie
Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions
suivantes:
• l'appareil ne doit pas produire de brouillage, et
• l'appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.

Assembly

To attach the product to a drill stand
• To attach the product to a drill stand, refer to the
manual for the drill stand.
• Use only with approved HUSQVARNA drill stands.
Refer to
Operation
9. Use the water system when you do wet drill
operations. Make sure that the water system is not
damaged. Refer to
drilling on page 16 .
10. Do a function check. Refer to
before you operate the product on page 14 .
To do a function check before you operate the
product
1. Do a check of the gear selector (A) to make sure that
it operates correctly and that it is not damaged.
Refer to
2. Do a check of the control panel (B) to make sure that
it operates correctly. Refer to
control panel on page 12 .
3. Do a check of the power trigger (C) to make sure
that it operates correctly and that it is not damaged.
Refer to
4. Charge the battery (D) and make sure that it is
correctly attached to the product. Refer to
To use
the product on page 16 .
5. Do a check to make sure that all parts are correctly
attached and not damaged or missing.
6. Make sure that the drill bit stops when you release
the power trigger. (Fig. 16)
CAUTION:
Read the operator's manual
for the drill stand carefully.
Applicable drill stands on page 22 .
To prepare the product for wet
To do a function check
To start the product on page 16 .
Functions of the
To examine the power trigger on page 13 .
1567 - 001 - 21.06.2021
To start