Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Do not use the ladder as a bridge.
•
Do not modify the ladder design.
•
Do not move a ladder while standing on it.
•
For outdoor use caution to the wind.
7.2 Additional requirements for safety marking and user instructions for leaning ladders
Leaning ladders with rungs shall be
used at the correct angle.
Ladders used for access to a higher level
shall be extended at least 1 m above the
landing point and secured, if necessary.
Do not lean the ladder against unsuitable
surfaces.
•
Ladder shall never be moved from the top.
7.3 Additional requirements for safety marking and user instructions for standing ladders
Do not step off the side of standing
ladder onto another surface.
Use the ladder with restraint devices
engaged only.
Do not stand on the top two steps/
rungs of a standing ladder without a
platform and a hand/knee rail.
If a ladder is delivered with stabi-
lizer bars and these bars should be
fixed by the user before the first
use this shall be described on the
ladder and in the user instruction.
Ladder for professional
use
Leaning ladders with steps
shall be used that the steps are
in a horizontal position
Only use the ladder in the dire-
ction as indicated, only if ne-
cessary due to design of ladder.
Do not stand on the top three
steps/rungs of a leaning ladder.
For telescopic ladders the last
metre shall not be used
Open the ladder fully before use.
Standing ladders shall not be
used as a leaning ladder unless it
is designed to do so.
Any horizontal surface which lo-
oks like a platform on a standing
ladder that is not designed for
standing on (e.g. a plastic work
tray) shall be clearly indicated on
that surface, (only if necessary
due to design of ladder).
EN
7
Werbung
Inhaltsverzeichnis
