Installation; Notice - Lacor 69424 Gebrauchs- Und Instandhaltungsanleitung

11.- Even after switching the lamp off it will remain hot for
several minutes, therefore do not touch it..
12.- Avoid using the heating lamp on windy, or rainy days.
1.- Open the large box. Remove all packing materials and protective covering from the unit and
parts. Do not discard the wrapping until you have checked that the blender is working
correctly.
2.- The lamp comes with a wall brackets and rings to allowing it to be hung from the ceiling.
Do not hang it in any other position but horizontal, with the reflector on top.
3.- Make sure that the ceiling, wall, lamp post or beam from which it will hang can support
around about four times the lamps' weight.
4.- Secure the brackets to the wall using the screws and plugs.
5.- Attach the lamp to the wall brackets with the screws provided.
Select the angle (up to 45º horizontally) and the direction the lamp will face.
6.- Connect the cable to the proper voltage outlet according to the necessary power; press the
switch located at the bottom and the pilot light should switch on.
7.- Insert batteries LR03 AAA (2) into the remote control, and press the power button to switch it
on, then select which lamp to light, using both buttons (heating or light).
8.- Make sure the switches are OFF before connecting the cable to the correct power supply.
1.- The power supplied to this unit must comply with electrical requirements on it's label.
Damage or fire may result if the incorrect power is used.
2.- Turn off all switches and unplug the unit should an emergency situation occur.
3.- Keep hands and other body parts clear of very hot parts. Otherwise injuries may result.
Of this device or in the case of a unit being used which has been abused; damaged either
accidentally or intentionally, modified, improperly installed or used in any manner contrary to
those included in the product instructions, guantee will automatically be canceled.
4.- The machine can not be washed or placed into water as it is not a waterproof device.
Putting the unit into water may result in electric shock and will damage the mechanical and
electrical components.
5.- Turn off and unplug the unit when performing maintenance or cleaning the unit.
6.- Turn the machine off if it appears to be operating in an unusual manner.
7.- Please contact the seller if you lose the operations manual for a replacement.
8.- Please contact the seller if you find other problems not covered in the operation manual.
32

INSTALLATION

NOTICE