Inhaltsverzeichnis
Werbung
General
•
If you notice a malfunction or detect power failure, turn the unit off immediately
and ensure it cannot start up again.
•
Problems must be fixed immediately.
•
Use properly qualified personnel to carry out repair work, thus ensuring the safe
operation of the unit.
•
Use only original FISAIR spare parts.
•
Refer to any local regulations that restrict or regulate the use of this dehumidifier.
Operation of the unit
•
Do not compromise the safety of the unit.
•
Periodically check the protection and warning devices.
•
The safety equipment of the unit must not be removed or left out of service.
Electrical components
•
Work affecting electrical components must be carried out by qualified electricians.
•
Use only original class fuses with correct calibration.
•
Perform regular checkups on the electrical equipment.
•
Defects, such as loose connections or burnt cables, should be repaired
immediately.
Installation, Disassembly, Maintenance and Repair of the Unit
•
The machine must not be tampered with when in operation.
•
Turn off power to the unit when maintenance or repairs are being performed.
•
Do not upgrade or install additional equipment on the unit without prior written
approval from FISAIR.
The I1 isolator switch must be placed in the "0"
position and locked out with a padlock to access
the fan plenum and/or perform any maintenance
action within the unit.
Similarly, the fuel, gas or steam feed valves must be locked out
in gas or steam equipment by means of a suitable mechanical
valve lockout, for maintenance.
Emergency stop to evacuate waste heat
The equipment does not have a general emergency stop on the control panel.
This is to avoid a possible accident due to not removing waste heat in the
reactivation flow. To stop in a situation of imminent risk or accident, use the I1
isolator identified in red and yellow and set it to position 0.
This should not be used to for a normal stop of the equipment.
Bedienungsanleitung baureihe DFLEX | 10
Werbung
Inhaltsverzeichnis
