Camille Bauer PRKAB 560 Betriebsanleitung Seite 6

Operating Instructions
Programming cable PRKAB 560
1. Warning
It is essential for the warnings given in the Operating Instruc-
tions for the programmed
... SINEAX M 561, M 562, M 563
... SINEAX TV 809, non-Ex version
instrument to be strictly observed.
The programming cable PRKAB 560 is only for use in con-
junction with a PC having an RS 232 C serial interface, or
with other suitable devices supplied by Camille Bauer Ltd.
No liability will be accepted in any other cases.
2. Scope of supply (acc. to order)
Programming cable PRKAB 560 (1)
Ancillary cable No. 143 587 (2)
Operating Instructions PRKAB 560 B d-f-e (3)
(1)
Fig. 1
DSUB
To PC
9p F
or
2 RXD
Laptop
3 TXD
RS 232 C
5 GND
Fig. 3. Schematic diagram PRKAB 560.
6
(2)
Betriebsanleitung
Programmierkabel PRKAB 560
Mode d'emploi
Câble de programmation PRKAB 560
Operating manual
Programming cable PRKAB 560
PRKAB560 B d-f-e 146 599 06 .00
Aar g auerstrasse 7
CH-5610 W ohlen/Switzerland
T elefon +41 56 618 21 11
T elefax +41 56 618 24 58
Camille Bauer AG T elex 827 901 cbm ch
+/–
+ –
3. Description
A PC, the programming cable PRKAB 560, the ancillary
cable and the configuration software M 560 resp. TV 800
plus are required to program the SINEAX M 56x and SINEAX
TV 809 Non-Ex. The programming cable also provides the
electrical insulation between PC and programming connector
on transducer.
The transducer can be programmed with the power supply
connected.
The connections between
PC ↔ PRKAB 560 ↔ SINEAX M 563 (e.g.) can be seen from
Fig. 2.
Programming connector
15 16 17 18 19 20
1 2 3 4 5 6 7 8 9 10 11 12 13 14
SINEAX M 563
Power
supply
(3)
Fig. 2
The data are transferred in a semi-duplex mode.
The built-in electronic circuits convert the standard
RS 232 C interface signals (± 10 V) to TTL signals of 0/5 V
which can be read by the instruments SINEAX M 56x and
SINEAX TV 809.
+5V
FCC
6p
Ancillary cable
Interface
Programming cable
PRKAB 560
To
USB
Camille Bauer
connector
instruments