Operating Oska Pulse; Power Off - Oska PULSE Gebrauchsanleitung

8. OPERATING OSKA PULSE

POWER ON
Press and release the button located on top
of the device to power on your Oska Pulse.
The device will emit a soft beep. LED lights
will begin to pulse at the perimeter of the
device to indicate PEMF is being emitted.
The PEMF session starts as soon as the
device is powered on. The device will start
a new session each time it is powered on.
Note: Most individuals will not feel the electromagnetic
field (PEMF) due to its low frequecy range. This is
normal and expected. Oska Pulse PEMF
therapy is non-invasive.

POWER OFF

Oska Pulse is preset to run for 90 minutes
without interruption, then automatically turn off when the duration completes. A session
can be stopped early by quickly pressing and releasing the power button three (3) times.
The device will beep and LED lights will turn off to indicate the device is powered off.
Figure 3: Turn on your Oska Pulse
14
On = 1-press
LED lights start flashing
Off = 3-press
LED lights stop flashing