Care And Cleaning - Gastroback DESIGN TOASTER DIGITAL 2S Bedienungsanleitung

Problem Reason
The bakery produce has
been too wet.
The bread slices are too
thick.
The room temperature
is too low or there is a
strong draught.
A heating element is
broken.
The start lever does not Bread sticks within the
spring to the idle position, bread slit.
although the heating time
elapsed.
A severe problem occur-
red.
The start lever does not You did not push the start
engage in the lower ope- lever down completely.
rating position.
The appliance is not live.
A severe problem occur-
red.
EN
56
The Solution
Do not attempt to toast very wet food that
could splash or drip!
Give the heating process some more time. For this, you
may activate the "DEFROST" function, select a higher
browning, or select another program (see: 'Operation /
Manual Operation').
Cut your bread slices somewhat thinner. Do not toast any
pieces of bakery produce in the bread slits that are thi-
cker than 2.5 cm (1 inch). If required, use the bun tray.
Give the heating process some more time. For this, you
may activate the "DEFROST" function, select a higher
browning, or select another program (see: 'Operation /
Manual Operation').
With a very low temperature and/or draught in the envi-
ronment of the appliance, the heating elements may not
reach the required temperature. Ensure a minimum room
temperature of 15°C.
Immediately unplug the appliance. Get in contact with an
authorized service centre for examination and repair.
Immediately unplug the appliance.
Ensure that the start lever and bread slices can always
move freely. Do not force any food into the bread slits.
Leave the appliance cool down completely. Then carefully
remove the bread (see: 'Operation / Removing a Bread
Slice Sticking in a Bread Slit').
Unplug the appliance. Get in contact with an authorised
service centre for examination and repair.
Push the start lever down to the stop.
Ensure to connect the appliance to a sufficient power
supply.
Unplug the appliance. Get in contact with an authorised
service centre for examination and repair.

CARE AND CLEANING

WARNING
– Always unplug the appliance and let it cool down, before
cleaning the appliance. Always ensure that all parts of the appliance are out of
reach of children younger than 8 years and animals. Do not spill or pour any
liquids in or on the appliance or power cord. Do not place or immerse the
appliance or power cord in any liquids. DO NOT place the appliance or power
cord in an automatic dishwasher!
CAUTION
– DO NOT poke in the bread slits. Do not use abrasive clea-
ning agents or aggressive liquids (e.g. bleach, solvents) or any hard or sharp-
edged objects (e.g. scoring pads, knives, scrapers) for cleaning the appliance or
any part of it. Do not use violence.
1. Switch off ("CANCEL" button) and unplug the appliance. Let it cool down to
room temperature. At the rear, pull the crump tray(s) out of the bottom of the
appliance. Empty the crump tray and, if required, via a dry nylon brush remove
any crumbs that stick to the surfaces. Push the crumb tray(s) back into place.
NOTE
The »DESIGN TOASTER DIGITAL 4S« (4 bread slits) has 2 crumb trays.
2. Clean the exterior of the appliance and, if requied, the bun tray via a soft cloth
that is damped with a little dishwater. Ensure that the cloth will not drip. In the
same way, wipe with clear water.
3. Wipe dry and leave the parts dry naturally for approx. 30 minutes.
EN
57