Description Of The Et35 "Touchscreen" Keys - Marmitek EASYTOUCH ET35 Betriebsanleitung

easytouch35_manual ok
18: Backlighting:
By pressing this key the screen will be illuminated. The backlighting will stay on while
pressing keys, and will time out ten seconds after the last key was pressed.
Error Indication
The LED flashes 3 times and the sounder beeps 3 times for any error condition.

5 Description of the ET35 "Touchscreen" keys

The Touchscreen Display
The Liquid Crystal Display (Touchscreen) acts as a "Virtual
Keypad" comprising a 15 position segmented "key" area.
Pressing the "SCREEN" key lets you toggle between two
available sets, or "screens" of keys for the mode you are in.
The display is normally blank when the remote is not in use. Pressing the Setup key, any
Mode key, the Macro key or any Touchscreen touch key turns the display panel on. The
remaining rubber keys do not activate the display.
6
All manuals and user guides at all-guides.com
6/17/03 10:30 AM Page 6
All the appliance can be controlled through 2
Touchscreens. Common screen keys are described below.
Numeric keys 0 - 9: For digit or numeric key entries e.g. to
select the channel number, or to enter the code of your device
-/--: In connection with the numeric keys this key allows you
to directly select channels higher than 9 (depending on the
appliance).
A/V: Selection of the SCART plug to view or record e.g. DVD,
SAT, VCR, ...
SEARCH: To scan up available program channels or tracks (see
chapter 15.4)
P<P: Allows to program 2 specific channels and switch
between them with a single key press (see chapter 11)
Master Screen
T - C
TV VCR DVD
2 3
S
LEVEL SETUP SLEEP
TUN ER STB AU X TAPE
O K
5
4 6
DSP MACRO EFFECT
CD AUDIO DISC
8
7 9
U SER1 LEARN USER2
A B AV M ODE 10
EX IT
M E N U 0 F A V
REPEAT CODE ENTER
SEARC H P<P
SCREEN
GUIDE
i
SV/V+ K EY?
MARMITEK