Klarstein HIGHTOWER HEAT 10032003 Bedienungsanleitung Seite 19

Timer function
This function will work in any mode. The timer function allows you to set the length of
operation from 1 to 8 hours.
To set the timer, press the
The display screen will show 1h, indicating the heater will operate for 1 hour before
shutting down to standby.
To increase the operation time, continue to press the "+" button until the desired
operation time is displayed. To cancel the timer feature press the "-" button until all time
indicator light off. This returns the heater to continuous running. Each press increase 1
hour.
Temperature setting
1. Operate the Heating Mode as per above instructions.
2. The LED screen will display the room temperature, to adjust the temperature,
press "+" to increase the desired temperature and "-" to decrease the desired
temperature.
• When the air temperature reaches 1 degree above the set temperature, the heater
will cut off. The heater stops working but the fan continues working to allow the
product to cool down and maintain the temperature.
• When the air temperature drops 3 degrees below the set temperature, the unit will
come back on.
• Temperature can be set from 10 degrees to 49 degrees, by pressing the "+" and
"-".
Safety system
• In the event of abnormal overheating, a safety device shuts down the appliance
automatically. After a short cooling down phase, the appliance is ready for use
again.
• If you still notice the same defect as above mentioned, remove the plug from the
socket and consult your authorized dealer to your after-sales service department.
• During use, do not touch or cover the air outlet. This may cause the unit to overheat,
and the safety device to operate.
• The unit is also fitted with a tip over switch. Do not use on thick and long pile
carpets, as the heater may not work, due the tip over switch not been activated.
button.
EN
19