Operation - Klarstein HIGHTOWER HEAT 10032003 Bedienungsanleitung

EN
18

OPERATION

WARNING
Risk of electric shock! Do not immerse or expose the product or fl exible
cord to rain, moisture or any liquid .
Before use
• Before use, remove all packaging and inspect the appliance for any damages. If
there are appears to be any damages, please take back to place of purchase for a
replacement.
• Ensure that all the accessories are included as per diagram above before you can
continue with the installation.
• Ensure that the location of the heater installed is not directly under a power socket
and that a power socket is available to power the appliances for use.
Operation
1. Carefully remove the heater from the plastic bag and the carton.
2. Place the heater on a fi rm level surface,.
3. Setting the master button to "off", on the base of the unit, plug the cord set into a
220-240 V~AC electrical outlet.
4. Plug in, switch the power point to the on position then turn the master button
on the heater to the on position, the heater in standby mode, LED display room
temperature °C, light, Please wait 3 seconds, then start to operate any function,
after 30 seconds, if no operation, light and LED switch off.
5. Turn the heater ON by pressing the ON/OFF button . The unit is now in fan mode.
This will conduct recirculation of the room air.
Now you can choose between 2 heating levels:
Heating leve 1 (1200 W): Press
Heating level 2 (2200 W): Press
6. To turn the heater OFF, press the ON/OFF button
NOTE: To assist in maintaining the internal components, after pressing the "ON/OFF"
button, the fan will continue to blow room air for a period of 30-60 seconds before
shutting down to standby.
Oscillating button
This heater has an oscillating function. To switch the function on, press the SWING
button .
button on the remote once.
button on the remote a second time.
.