Connecting And Preparing Your Tv Checking Parts; Using The Stand-Base; How To Assemble The Stand-Base (Depending On The Model) - Samsung 8 Serie Bedienungsanleitung

Connecting and Preparing Your TV
Checking Parts
Owner's Instructions Remote Control/
AAA Batteries (2ea)
Cover-Bottom
(PS50B859 only)
AV Cable Component Cable
Ferrite Core
N
The ferrite cores are used to shield the cables from interference.
When connecting a cable, open the ferrite core and clip it around
the cable near the plug.

Using the Stand-Base

Two or more people should carry the PDP. Never lay the PDP on the floor
N
because of possible damage to the screen. Always keep the PDP upright.
The PDP can rotate 20 degrees in right and left directions.
N
How to assemble the Stand-Base
Using the 5 screws for securing the stand base and the TV, firmly attach the TV
to the stand base.
(The exterior of the set may be different than the picture.)
All manuals and user guides at all-guides.com
Program CD
Screws (5ea) Cover-Bottom/Screw
(PS50B859 only) (PS58B859 only)
Holder-Wire Cable
(Refer to page 67)
Warning
Firmly secure the stand to the TV before moving
it, as the stand may fall and could cause serious
injury.
Two or more people should carry the TV.
N
Never lay the TV on the floor because of
possible damage to the screen.
Always store the TV upright.
Cloth-Clean
Holder-Wire stand
(Refer to page 67)
Ferrite Core (4ea)
Power Cord (2ea)
(depending on the model)
In case of installing your TV on the wall, close the
cover (1) on the stand-base connection part using
two screws for hiding.
English - 4
Holder-Ring (4ea) Warranty Card/
(Refer to page 66) Safety Guide Manual
(Not available in all
locations)
Holder-Wire (3ea) Ext Cable
(Refer to page 67)
LAN Cable HDMI Cable
(1ea)
-20° ~ 20°
(1ea)