Maintenance; Checking / Factory Inspections; Scs Certificate; Guarantee - Schiltknecht Messtechnik ThermoAir3 Bedienungsanleitung

ThermoAir3

Maintenance

Checking / Factory Inspections:

Depending on the application and the loads on the instrument, we consider it
highly advisable to have the instrument, respectively the probe annually
checked or inspected / repaired at our factory.

SCS certificate:

Schiltknecht Messtechnik AG is an authorised calibration centre for the Swiss
Calibration Service SCS for flow rates (air).
(Accredited by the WECC Western European Calibration Cupertino).
The accrediting refers to the calibration of flowmeters for air velocities. On the
basis of a multinational agreement between national calibration agencies, this
is recognised in the following countries:
BRD, CH, I, GB, NL, S, F, SF, DK, N, IE, SA and A.
The certification is performed with our laser-doppler wind tunnel according to
certificate EN17025.
Accreditation number SCS 046.

Guarantee

Our guarantee covers verifiable material or manufacturing defects on systems
and devices for a period of 12 months from delivery. For manhandling the
guarantee is not applicable.
In the case of an event bringing the guarantee into operation, the defective
part is repaired or replaced according to our choice. Transport and travel costs
are paid by the ordering party.
The guarantee provisions of the supplier are applicable for non-Schiltknecht
material.
We accept no liability with respect to the suitability of the delivered products for
the envisaged application.
Our guarantee is in all cases limited to the defective device. Liability for any
secondary damages whatever is expressly ruled out.
Schiltknecht Messtechnik AG 45