Quick Setup - Behringer BIGFOOT Bedienungsanleitung

32 BIGFOOT
BIGFOOT Getting Started

Quick Setup

1. Set the microphone so that the MUTE and
VOLUME controls are facing you in your
recording position.
2. Tighten the screws on either side to keep the
microphone at your chosen angle.
3. Run the supplied USB cable from the USB output
on the bottom to your computer.
4. Be sure to select BIGFOOT as your audio device
for recording/playback in your computer.
5. While speaking or playing into the microphone,
watch the input meter of your recording
software or interface. Use the GAIN knob to
increase or decrease the signal from
the microphone, depending on the level shown
in your meter, until you find a usable level.
Drivers
The microphone should run automatically when
plugged into your computer's USB input without
need for any further drivers.
Recommended Operating Systems:
Windows* Windows 10 (64-bit)
Mac** OS X 10.10 or higher
*Windows is either a registered trademark or
trademark of Microsoft Corporation in the
United States and/or other countries.
**Mac/Macintosh and OS X are either registered
trademarks or trademarks of Apple Computers in
the United State and/or other countries.
If necessary, you can download the universal
ASIO4ALL USB driver for Windows for free by going
to the download section on the BIGFOOT
product page.
BIGFOOT may also work with iOS, Android and
Linux devices, depending on your specific hardware
and operating system version. For example, if your
smartphone supports USB On-The-Go and delivers
sufficient power to run the microphone, then you
should be able to use BIGFOOT in mobile
recording situations.