Trust SC-5250 5.1 Bedienungsanleitung Seite 27

Product information
A: Analog audio connectors
i
B: Digital audio connectors (Optical S/PDIF)
C: Digital audio cable (Optical fibre)
Hardware Installation
Power down PC and disconnect power plug.
1
Open PC Case.
2
Place card in PCI slot.
3
Connect Power plug and Power on PC.
4
Software Installation and basic settings
Click: Cancel
5
Place Trust Installation CD
6
Click: Install driver and restart PC.
7
Note: when the setup prompts there is no card found, install the card in a different PCI slot. (step 1)
Note: If there are other problems, try to uninstall other soundcard drivers first and disable the onboard
soundcard in the PC BIOS. (see motherboard manual). After this install the Trust driver again.
Click Trust taskbar Icon
8
Vista: Select 6 Channel system input and 5.1 Speakers analog output.
9
XP: Select 6 Speaker analog output.
10
Connecting speakers and other devices
For a 5.1 speaker set, Side Out can be left out.
11
Connect MP3 player and Microphone as indicated. To set up recording from one of these sources go to
12
16
Step
13
Connect S/PDIF Input and Output as indicated. Check step
Advanced Use
Advanced speaker settings
14
Click the Hammer icon to change advanced settings. (Only available in 5.1 speaker output mode)
1: Swap center/bass output: this option corrects a problem with some speaker sets that the center speaker
produces the sound of the subwoofer.
2: Bass Enhancement: Activate subwoofer during music playback.
Digital Output (S/PDIF)
15
15
for S/PDIF configuration.
1