BRAX NOX-4 Bedienungsanleitung Seite 20

4 CPS - Colour Protection System
The LEDs show the operation status of the amplifier. Yellow (11) = malfunction: short-circuit at speaker output;
Red (12) = overheated: If the amp shuts off due to overheating it will take some time (depending on the outside tempera-
ture) until it turns on again.
5-6 Connectors for a BRAX Power Stabilizer
If a BRAX Power Stabilizer is connected to this terminal peak loads in the power supply will be eliminated. Thus, the am-
plifier has always enough power for its perfect performance.
Equipment and control units
7, 9 Loudspeaker terminals
To connect the speaker cables. Never connect the loudspeaker cables with the car chassis ground. It damages your
amplifier. All speaker systems must be connected in-phase, it means plus to plus and minus to minus. Inverting plus and
minus will result in the loss of bass rendition. The positive terminal is marked on most speakers.
8 Signal inputs
The amplifier has RCA connectors for RCA cables that can be connected with the pre-amplifier outputs of a headunit or
pre-amplifier. The connectors are gold-plated to ensure a better signal transmission.
Please note that all signal inputs have to be connected in bridged mode in order to reach full output level.
20
All manuals and user guides at all-guides.com