About This Guide; Desktop Or Shelf Installation - D-Link SmartPro GS-1510-28P Erste Schritte

About This Guide

This guide gives step-by-step instructions for setting up
all D-Link SmartPro switches and relative Warranty,
Safety, Regulatory, and Environment Notice. Please note
that the model you have purchased may appear slightly
different from those shown in the illustrations.
For more detailed information about your switch, its
components, making network connections, and technical
specifications, please refer to the User's Guide included
with your switch.
Step 1 – Unpacking
Open the shipping carton and carefully unpack its
contents. Please consult the packing list located in the
User Guide to make sure all items are present and
undamaged. If any item is missing or damaged, please
contact your local D-Link reseller for replacement.
- One D-Link SmartPro Switch
- Rack mounting bracket
- Rubber Feet
- Power cord
- One console cable
- Power cord clip
- User's Guide CD with DNA (D-Link Network Assistant)
program
- One multilingual Getting Started Guide
Step 2 – Switch Installation
For safe switch installation and operation, it is
recommended that you:
• Visually inspect the power cord to see that it is secured
fully to the AC power connector.
• Make sure that there is proper heat dissipation and
adequate ventilation around the switch.
• Do not place heavy objects on the switch

Desktop or Shelf Installation

When installing the switch on a desktop or shelf, the
rubber feet included with the device must be attached
on the bottom at each corner of the device's base. Allow
enough ventilation space between the device and the
objects around it.
Figure 1. Attaching the rubber feet
2
All manuals and user guides at all-guides.com
Installing Power Cord Clip
To prevent accidental removal of the AC power cord, it is
recommended to install the power cord clip together with
the power cord.
1. With the rough side facing down, insert the Tie Wrap
2. Plug the AC power cord into the power socket of the
3. Slide the Retainer through the Tie Wrap until the end
4. Circle the tie of the Retainer around the power cord
into the hole below the power socket.
Figure 2-1. Insert Tie Wrap to the Switch
Switch.
Figure 2-2. Connect the power cord to the Switch
of the cord.
Figure 2-3. Slide the Retainer through the Tie Wrap
and into the locker of the Retainer.
Figure 2-4. Circle around the power cord