Medistrom Pilot-12 Lite Bedienungsanleitung Seite 15

All manuals and user guides at all-guides.com
Blue LED flashing The
accompanied by environmental
long (1s) beeping temperature is
pattern too high for the
battery to
operate safely
Blue LED flashing Incorrect AC
accompanied by adapter being
short (500ms) and used
long (1s) alternate
beeping pattern
PAP device
connected
to battery is
incompatible
Four green LEDs Incorrect AC
flashing together adapter being
accompanied by used
long (1s) beeping
pattern
Blue LED flashing PAP device
accompanied by connected
a short (500ms) to battery is
short (500ms) incompatible
long (1s) beeping
DC output cable
pattern
is damaged
Blue LED flashing PAP device
accompanied connected
by three short to battery is
(500ms) beeping incompatible
pattern
Blue LED Maximum battery
periodically power output
flashing (no
pattern)
Blue LED flashing Battery capacity is
every 0.5 seconds below 5%
Ensure that the battery is placed
where there is no excess heat. Do not
rest the battery on top of radiators or
electronic devices that may emit heat.
Do not attempt to use the battery in
temperatures exceeding 40° C / 104° F
Pilot-12 Lite: use the AC adapter
provided with your
DreamStation or Respironics System
One S60 or other
power adapters (see section
Pilot-24 Lite: use the AC adapter
provided with your ResMed S9 or
ResMed AirSense 10 or the Medistrom
AC adapter (see section 2.3).
Ensure that the PAP device you are
using is compatible with the Pilot-12
Lite or Pilot-24 Lite (see sections 1.3
and 2.3 respectively)
Pilot-12 Lite: use the AC adapter provided
with your Respironics DreamStation or
Respironics System One S60 or other
compatible power adapters (see section
1.3)
Pilot-24 Lite: use the AC adapter provided
with your ResMed S9 or ResMed AirSense
10 or the Medistrom AC adapter (see
section 2.3)If problem persists please
contact Medistrom technical support at
1-888-407-4791 (North America), 1-300-
146-358 (Australia) or email support@
medistrom.com
Ensure that the PAP device you are
using is compatible with the Pilot-12
Lite or Pilot-24 Lite (see sections 1.3
and 2.3 respectively)
Ensure that the cable connecting the
Pilot-12 Lite or Pilot-24 Lite to your
compatible PAP device is not damaged
Ensure that the PAP device you are
using is compatible with the Pilot-12
Lite or Pilot-24 Lite (see sections 1.3
and 2.3 respectively)
No action required, the battery is
operating correctly. Depending on
your prescribed pressure, enabled
PAP device features and breathing
rate the battery may reach maximum
power output which is indicated by the
periodically flashing blue LED
Charge the battery as soon as
possible. The battery power level is
critically low. Not charging the battery
for a prolonged period will cause it to
go into Over Discharge State.
Respironics
compatible
1.3).
15