Installation; Before The Installation; Injectors Replacement - Zanussi ZGG35214 Benutzerinformation

Installation

WARNING!
Refer to Safety chapters.

Before the installation

Before you install the hob, write down the
information bellow from the rating plate. The
rating plate is on the bottom of the hob.
Model .......................................
PNC .........................................
Serial number ...........................
Gas Connection
WARNING!
The following instructions about
installation, maintenance and
ventilation must be carried out by
qualified personnel in compliance
with the regulation in force (UNI-CIG
7129 - 7131). Make sure that the
kitchen is well ventilated: keep
natural ventilation holes open (at
least 100 cm²) or install a
mechanical extractor hood.
Choose fixed connections or use a flexible pipe
in stainless steel in compliance with the
regulation in force. If you use flexible metallic
pipes, be careful they do not come in touch with
mobile parts or they are not squeezed. Also be
careful when the hob is put together with an
oven.
Make sure that the gas supply
pressure of the appliance obeys the
recommended values.
If the supplied pressure has not the specified
value, it is necessary to assemble a proper
pressure regulator in compliance with the
standard UNI EN 88. For Liquid Gas (LPG) the
use of pressure regulator is allowed only if they
are in compliance with UNI EN 12864. The
adjustable connection is fixed to the
comprehensive ramp by means of a threaded
nut G 1/2". Screw the parts without force,
adjust the connection in the necessary direction
and tighten everything.
10
A
A) End of shaft with nut
B) Washer
C) Elbow (if needed)
Rigid connection:
Carry out connection by using metal rigid pipes
(copper with mechanical end) (UNI-CIG 7129).
Flexible connection:
Use a flexible pipe in stainless steel (UNI-CIG
9891) with a maximum length 2 m.
WARNING!
When installation is complete, make
sure that the seal of each pipe fitting
is correct. Use a soapy solution, not
a flame!

Injectors replacement

1. Remove the pan supports.
2. Remove the caps and crowns of the burner.
3. With a socket spanner 7 remove the
injectors and replace them with the ones
which are necessary for the type of gas you
use (see table in "Technical Information"
chapter).
4. Assemble the parts, follow the same
procedure backwards.
5. Replace the rating plate (it is near the gas
supply pipe) with the one for the new type
of gas supply. You can find this plate in the
package supplied with the appliance.
If the supply gas pressure is changeable or
different from the necessary pressure, you must
fit an applicable pressure adjuster on the gas
supply pipe.
B C
www.zanussi.com