Troubleshooting - Polar CD229 Bedienungsanleitung

Should the parameter need adjusting:
1. Press and hold the SET button for six seconds. The "E1" parameter is displayed.
2. Press the or buttons until the required value is displayed.
3. Press the SET button to store the new value and cycle to the next parameter.
NOTE: The controller times out after 10 seconds if no buttons are pressed.
Manual Defrost:
Press and hold the button for 6 seconds to begin automatic defrost. The defrost light illuminates.
Cleaning, Care & Maintenance
1. Switch off and disconnect from the power supply before cleaning.
2. The doors can be removed for ease of cleaning.
3. Clean the interior of the appliance as often as possible.
4. Do not use abrasive cleaning agents. These can leave harmful residues.
5. Clean the door seal with warm soapy water.
6. Always wipe dry after cleaning.
Replacing the Interior Lamp
Call your POLAR dealer or a qualified electrician, the Lamp Assembly is available to purchase as a spare
part.
Cleaning the Condenser
Periodically cleaning the condenser can extend the life of the appliance. POLAR recommend that a POLAR
agent or qualified technician clean the condenser.

Troubleshooting

If your POLAR appliance develops a fault, please check the following table before making a call to the
Helpline or your POLAR dealer.
Fault
The appliance is not
working
CD229-CD230_ML_A5_v5_20210106.indb 5 CD229-CD230_ML_A5_v5_20210106.indb 5
Probable Cause
The unit is not switched on
Plug and lead are damaged
Fuse in the plug has blown
Power supply
Internal wiring fault
Solution
Check the unit is plugged in correctly and
switched on
Call POLAR agent or qualified Technician
Replace the fuse
Check power supply
Call POLAR agent or qualified Technician
UK
5
2021/1/6 15:35 2021/1/6 15:35