Swim & Fun eeese air cooler 1000 Benutzerhandbuch Seite 43

UK
Cleaning
The evaporator and the static filter may become clogged with dust or dirt. This will affect
the air volume and the cooling system. It is recommended that it is cleaned at least every
second week. The cleaning procedure is as follows:
• Disconnect the power supply.
• Loosen the filter screen tabs at the top and remove the filter screen and the
evaporator grille.
• Rinse both with clean, lukewarm water without the use of soap.
• Replace the evaporator grille and filter screen to their original positions.
NOTE
The evaporator grille must be installed the correct way round, otherwise you may
experience water leakage from the grille.
NOTE
If the water pump is not working or functioning abnormally, you must clean the water
inlet.
If water cannot be drained, you need to disassemble and clean the bottom valve and the
valve core. Clean the inside of the outlet valve and replace it in its original position.
In order to achieve optimal performance, make sure there is ample clearance
around the unit when it is in operation. Otherwise, the service life will be
affected and in severe cases the motor can burn out.
Relocation of the unit
If the unit needs to be moved to another position, it must be done slowly and carefully, to
avoid the water in the tank overflowing. We recommend that the water tank is removed
before the unit is moved.
43
MV-2510-12-2020 . swim-fun.com © All rights reserved Swim & Fun Scandinavia ApS