Preparation And Operation; Filling With Water - Swim & Fun eeese air cooler 1000 Benutzerhandbuch

UK
2.

Preparation and operation

Unpack the unit and make sure that the instruction manual, remote control and castors
are enclosed.
The unit must be placed on a horizontal surface. The unit must not be tilted when it is in
operation.
Check the power supply and ensure that it is in accordance with the parameters of the
air cooler.

Filling with water

If the unit is new or has not been in use in the cooling mode for a long period of time,
it will be necessary to fill it up with clean water before use. The power supply must be
disconnected before filling with water, in order to prevent damage to the electrical parts.
Release the catch on the water container and remove the water tank. Fill the tank with
water up to the maximum – not over, as the water may overflow.
Mounting of casters
Assemble the casters without brake
Mounting of casters
on the front and the casters with
Assemble the casters without brake on the front and the casters with brake on the back
brake on the back.
front casters
front casters
back casters
back casters
Storage
If the unit will not be used for a long period of time, the water tank must be emptied and
cleaned. Allow the device to blow at the normal temperature for a while, in order to dry
the system. In particular, the filter should be completely dry. We recommend that the unit
is kept in its original packaging.
42
Mounting of casters
Assemble the casters without brake on the front and the casters with brake on the back
i¼o
front casters
m
J
back casters
i¼o
m
J
MV-2510-12-2020 . swim-fun.com © All rights reserved Swim & Fun Scandinavia ApS
Water level