Visual Inspection Of The Flame; Accessories - Dometic FO250SA Installation, Gebrauch, Wartung

FO250SA - FO250FSA - FO252SA - FO252FSA
Manual ignition of the grill
If the electronic ignition does not work, the manual ignition is used as a
substitute.

To generate the flame, fully press down the control knob and turn it to
position grill (Fig. 6, page 5).
 Simultaneously ignite the burner with a match or gas lighter.
 Once the flame has been generated, press the knob down for a few
seconds so that the flame remains lit.
CAUTION!
If the burner does not turn on:
● check that there is gas in the cylinder.
If the device does not work, close the gas inlet tap and contact
your dealer.
Regulating the grill flame

The grill is to be used only at its rated thermal capacity.

7.4 Visual inspection of the flame

Depending on the type of gas used, the flame appears as follows:
● Propane (G31): flame with blue internal pin point and clear outline.
● Butane (G30): flame with slight yellow tips when igniting the burner;
these tips intensify as the burner heats.

7.5 Accessories

The rack and drip pan have a block that prevents accidental extraction (Fig.
7, page 6).
For a correct insertion, the blocks must be facing upwards and toward the
inside of the appliance.
To extract, slightly lift the front of the rack or the drip pan.
EN
Use
35