TESY CN03 YYZ MIS F Bedienungs Und Aufbewahrungsanleitung Seite 2

IMPORTANT SAFETY MEASURES AND INSTRUCTIONS:
EN
WARNING!
• Please read this manual before operating the appliance and keep it at a
safe place for future reference. In case the appliance is obtained by a new
owner, it should be transferred together with its manual.
CAUTION: Children under 3 years of age should be kept away from the
•
appliance unless they are under constant supervision.
Children from 3 to 8 years of age are allowed to operate the on/off button
ONLY, provided that the appliance is installed and ready for operation and
such children have been supervised and instructed in safe operation of the
appliance and they understand all related risks.
Children from 3 to 8 years of age MUST NOT: connect the plug to power
sockets, make adjustments, clean it or carry out user maintenance
operations.
This appliance can be used by children older than 8 years of age and
by people with reduced physical, sensor and mental capabilities, as well
as by people with insufficient experience and knowledge provided they
are supervised or instructed in safe operation of the appliance and
understand the related risks. Children should not be allowed to play with
the appliance. Cleaning and user maintenance operations must not be
carried out by children without supervision.
• CAUTION: Some of the appliance parts may get very hot during operation
and thus cause burns to users. In case there are children and vulnerable
people in the room, special attention should be paid.
• WARNING: Do not cover the appliance in order to
prevent overheating!
• The appliance must not be placed right under a socket box!
• If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
• Before connecting the appliance to the mains, check if the voltage
indicated on its technical plate corresponds to the voltage of the
electricity, supplied to your house.
• This appliance shall be used only for the purpose it has been designed
and intended for, i.e. heating of domestic premises. The appliance is not
intended for commercial/industrial application. Every other use is to be
considered improper, and therefore dangerous. The manufacturer doesn't
bear responsibility for damages arising from improper and irrational use.
Non-adherence to these instructions would render the warranty invalid!
• Do not leave your home while the heater is operating: make sure that the
power switch is in OFF position (panel heaters with mechanical control).
• Keep inflammable objects, such as furniture, pillows, bedding, paper,
clothes, curtains etc. at a safe distance of at least 100 cm away from the
panel heater.
• Do not operate the appliance in areas of use or storage of combustible
substances. Do not operate the appliance in areas of combustible media
(for example in close proximity to inflammable gases or aerosols) – there is
great risk of explosion and fire!
• Do not insert and do not allow foreign objects to enter the ventilation
openings (inlet and outlet) because this will cause electric shock, fire or will
damage the appliance.
• The appliance is not suitable for animal breeding. The panel heater is
intended for domestic/indoor operation only.
• When positioning the appliance, do not cover the safety grilles; do not
hamper the incoming and outgoing air flow. All objects must be at a safe
distance of at least 1 meter away from the appliance front and sides.
• The most common reason for overheating is dust and fluff deposits in the
appliance. Clean the ventilation openings on a regular basis with a vacuum
cleaner, but before that it is very important to disconnect the heater from
the mains.
• Never touch the appliance with wet or moist hands – there is risk for your life!
• The power socket should be accessible all the time in order to disconnect
the power plug when needed as fast as possible! Never pull the power
cord or the appliance itself in order to disconnect it from the mains.
• PAY ATTENTION! Outgoing air gets heated during appliance operation (up
to more than 100°С).
• If you decide to stop using an appliance of this kind, it is recommended to make
it unusable by cutting its power cord after you have disconnected it from the
mains. It is advisable all possible risks related to the appliance to be secured,
2
Operation and Storage Manual of Panel Heater
especially in relation to children that may play with out-of-use appliances.
• Warning: Do not use this appliance with a programmer, counter or any
other mechanism which could automatically turn on the heater – if the
appliance is covered or positioned incorrectly there is a risk of fire.
• Position the power cord in such a way that it does not obstruct the free
movement of people and cannot be stepped on! Use only approved extension
cords, which are suitable for this appliance, i.e. they have a compliance sign!
• Never move the appliance by pulling its power cord; do not use the power
cord for carrying other objects!
• Do not bend the power cord and do not pull it against sharp edges; do not
place the power cord on hot surfaces or open fire!
PACKING
• After unpacking the appliance, check if its contents are intact and if it has
not been damaged during transportation! In case a damage or incomplete
delivery is found, contact your authorized retailer!
• Do not dispose of the original packing box! It could be used for
storage and transportation purposes in order to avoid damages during
transportation!
• Disposal of packing material should be done in the appropriate way!
Children must be prevented from playing with polyethylene bags!
OPERATION AND INSTALLATION OF FEET SET
• This panel heater is designed to be used indoors.
In accordance with Regulation EU 2015/1188 implementing Directive
2009/125/EC this electric heating appliance is not intended for wall installation!
Important: In premises bigger than 45 m3, it is recommended to use a
combination of 2 or more panel heaters.
• Do not position the panel heater under a power socket or electricity
connection box.
• DO NOT install/operate the panel heater:
1. in places where a draught is present, which could influence the control
settings;
2. right under a power socket;
3. in "Volume 1" for bathrooms;
4. in "Volume 2" if the control board can be reached by a person who is in
a shower or in a bathtub;
• Before starting the set installation check if the panel heater is disconnected
from the power socket!
• The feet are to be installed at the air inlets – it is correct them to be
installed at the two sides ends of the panel heater in a symmetrical
manner – at the same distance from the sides ends of the panel heater.
For installation purposes – all panel heaters have got two 2x2 openings.
• Mount the first foot – by inserting first the higher part of the foot into the
panel heater (you should stand opposite of the face of the panel heater)
– the part is lower than the front metal panel. Then you should take a
Phillips screw-driver (not included in the product set) and screw in the two
3.5x9,5mm securing screws. The screw goes through the plastic foot and
gets screwed into place in the metal body of the panel heater. You should
repeat the same operation for the second foot.
• The joint is secure in case the panel heater stands horizontally on the floor
after its feet installation has been completed. Do not use the power cord
as a pulling rope in order to move the panel heater; any movement of the
panel heater should be done when it is cold.