Specifications - DeVilbiss drive c-Go 24V/4A Bedienungsanleitung

English
All LEDs are blinking
simultaneously
Table 2: Error codes
Error code(s) Description
1, 2 , 3 Internal battery
charger problem.
4 Temperature too low.
5 Temperature too high
6 Too many ampere
hours charged.
8 Voltage increase
insufficient.
If the cause of the failure has been removed, the battery charger can be restarted by
disconnecting and reconnecting the mains .
12.

Specifications

c-Go specifications /
model
Supported batteries
Battery capacity range
Mains voltage
Mains frequency
Output voltage range
Output current range
Maximum output power *
Efficiency
Protections
Dimensions
Charge status indication
Problem detected.
Possible causes and solution(s)
Restart battery charger. If the error is repeated
Consult Your supplier.
Move to a warmer environment and restart the
charging.
Let the charger cool down for 15 minutes and
restart the charging. If the problem persists
please consult Your supplier.
1: Connected a battery with higher capacity then
specified.
2: Unknown problem. Please consult Your
supplier.
Possibly a defective battery.
Please consult Your supplier.
4A 6A
Lead Acid (Gel/ AGM) 24V or 2 x 12V
25-40Ah 40-60Ah
220-240Vac
0.25 – 4A 0.25 – 6A
120W 180W
Polarity , Output voltage , Temperature
16
Count the number of flashes
between the pauses and consult
table 2
8A
60-85Ah 70-105Ah
(single phase)
nominal,
50/60 Hz
24V nominal
0.25 – 8A 0.25 – 10A
240W 300W
> 90% at full load and 230Vac
210 x 175 x 65mm
2 LEDs
10A 12A
80-125Ah
0.25 – 12A
360W