Technical Data (A); Function Of The Unit; Overview (A); Start Of Operation - Berner BACFP 18V Bedienungsanleitung

Transporting li-ion battery packs: The contained lithium-ion batteries are subject to the Dan-
gerous Goods Legislation requirements. The user can transport the batteries by road without fur-
ther requirements. When being transported by third parties (e.g.: air transport or forwarding
agency), special requirements on packaging and labelling must be observed. For preparation of
the item being shipped, consulting an expert for hazardous material is required. Only send the
battery pack if the housing is intact and no fluid is leaking. Remove the battery pack from the
machine for sending. Prevent the contacts from short-circuiting (e.g. by protecting them with ad-
hesive tape).
Dispatch batteries only when the housing is undamaged. Tape or mask off open contacts and
pack up the battery in such a manner that it cannot move around in the packaging. Please also
observe possibly more detailed national regulations.
2 Technical Data
Battery:
U = Voltage
C = Capacity
W = Weight
Ic = Charge current
t = Approx. charging time (90% full)
Charging voltage ............................ 20,75 V DC
Charging temperature ..................... 0° - 50° C
Max. discharging temperature. ....... 5° - 50° C
Recharge battery pack before first use!
3

Function of the Unit

3.1 Overview
Battery pack
1
Sliding seat
2
Operation display
3
3.2

Start of operation

Before plugging in, check to see that the rated mains voltage and mains fre-
quency, as specified on the rating label, match your power supply.
Devices such as this one, which generate direct current, may have an effect on basic residual-
current circuit breakers. Use type F or better, with a release current of max. 30 mA.
Before commissioning the charger, ensure that the air slots are free. Minimum
distance to other objects is 5 cm.
Self-test:
Insert mains supply plug.
The warning display (4) and the operating indicator (3) light up one after the other for approx. 1
second and the installed fan runs for approx. 5 seconds.
Battery pack:
Charge the battery pack before use (1).
If performance diminishes, recharge the battery pack.
The ideal storage temperature is between 10° C and 30° C. The permissible storage temperature
is between 0° C and 50° C.
Charger:
U1 = Input voltage
f1 = Input frequency
P1 = Input power
U2 = Charging voltage
I2 = Max. charge current
Nc = No. of battery cells
W = Weight
Pay attention to the electrical outlet
voltage! Check the label on the bottom
of the charger!
Warning display
4
Capacity indicator button
5
Capacity and signal indicator
6
ENGLISH
(A)
(A)
13