Airwell AW-CDV09-N11 Betriebs Und Installationsanleitung Seite 9

Maintenance
Install the air cleaner & Inlet guide plate
1.Install the air cleaner: The method is contrary to the method ofremoving the dust screen.
2.Install the Inlet guide plate: As shown below, the rack on the return air guide plate is inserted into the gear box.
Cleaning the air outlet port and the shell
• Don't use gasoline, benzene, diluents, polishing powder or liquid insecticide to clean them.
• Do not clean them with hot water of above 50°C to avoid fading or distorting.
• Wipe them with soft dry cloth.
• Water or neutral dry cleanser is recommended if the dust cannot be removed.
• The Wind Deflector can be dismantled to clean.
• Do not wipe the wind deflector with water forcibly to avoid the floss falling off.
Maintenance before and after Operating Season
Before Operating Season:
1. Please make the following checkup:
• There is no blockage in inlet port and outlet port of
outdoor and indoor units.
• The ground line and the wiring are in the proper state.
If abnormal condition occurs, consult the after-service
personnel.
2. Clean the air cleaner and the shell.
• After cleaning, the air cleaner must be mounted.
3. Switch it on to the power.
• After cleaning, the air cleaner must be mounted.
The hole of gear wheel box
Attention
Attention
Rack
After Operating Season:
1. In sunny days, blowing operation can be performed for
half a day to make the inside of machine dry.
2. Switch it off.
• Electrical power should be cut down to economize
electricity, or the machine will still consume power.
3. Clean the air cleaner and the shell.
• Air cleaner and shell must be mounted after cleaning.
For cleaning details, refer to Maintenance.
6