Safety Advice; Maintenance Instructions - LAGUNA BADWELTEN Magic Montageanleitung

SAFETY ADVICE

• The mounting must only be done by experts.
• Warning: defective mounting is dangerous!
• Check whether the wall is suitable for the mounting and
that the fasteners are strong enough for the forces involved.
• Please read through the mounting instructions carefully
before mounting in the bathroom.
• The enclosed fastening material is only suitable for solid
walls of sufficient load-bearing strength.
• If the nature of the wall is different (e.g. plasterboard or
lightweight walls), a different fastening which is suitable for
the load should be chosen by the customer.
• Electrical installations should only be carried out by a
specialist electrician DIN VDE 0100-701 (VDE 0100-701):2008-10.
• Electrified, mirrored cabinets and flat mirrors must be locat-
ed at a minimum distance of 600 mm away from the bath or
shower.
• The safety regulations and standards of the particular coun-
tries must be observed.
IMPORTANT INFORMATION
• Inspect the packaging for external damage when it is delivered.
• Please check the number of bathroom cabinets supplied and
the associated sets of ironmongery (screws, cover caps,
handles, etc.) against the delivery note or the article's label
on the packaging.
• Caution: only remove the protective caps on the mirrored
cabinet's doors after mounting the doors, in order to avoid
damaging edges of the mirrors.
• Use suitable spacers or distance blocks to even out the
existing differences in level caused by coverings applied to
the walls, e.g., partial tiling.
• Reinforce any walls of insufficient load-bearing strength.
• The drilled dimensions are measured from the FFL according
to the dimensioned layout.
• Fasten the cabinets with the suspension rails:
- Washstand base cabinet, Highboard
- Tall cabinets (600 mm width)
- Vanity unit with top drawer
• Always fasten the hanging bar to the wall with 2 screws!
• Note the different suspension height for the mirrored cabinet
and the flat mirror.
• The horizontal spacing between the cabinets can be chosen
freely.
• Do not tighten water tap and sink pop-up too firmly.
• Bonding between washstand and shelf with silicone
(transparent and solvent-free).
• Pay attention to the assembly/installation instructions (addi-
tionally enclosed).
TOOLS
• Jig saw
• Drill and battery-operated screwdriver
• Stone drill bit of 8 mm dia, 14 mm dia
• Wood drill bit of 4 mm dia, 10 mm dia
• Folding metre rule and measuring tape
• Spirit level
• Screwdriver with a 3.5 mm tip for Phillips screws
• 8, 10, 17 wide open-jawed spanner
• 4 mm Allen key
• Screw clamps
• Pencil
• Silicone sealant (transparent and solvent-free)
c Laguna Magic

MAINTENANCE INSTRUCTIONS

• Caution: do not use any chemicals, aggressive detergent
paste or scouring powder.
• The best way of cleaning the cabinet is to use a damp cloth
with some mild washing-up liquid.
• Take care that no residue from droplets remains on the lower
edge of bathroom cabinets.
• Polish the mirror with a damp cloth or chamois leather.
• The washbasin can be easily cleaned with any of the usual,
non-abrasive cleaning agents.
• Ventilate regularly in order to prevent the mould from forming.
KEEP THE INSTRUCTIONS IN A SAFE PLACE
i
Caution: keep the instructions safely because they contain
information about installing and operating the products.
MOUNTING SEQUENCE
i
For the figures, see the attachment
1. Remove the doors and drawers (Fig. A/A1)
2. Mount the lamps (Fig. B)
The mains wire should not be live!
3. Install cornice light (Fig. B1)
4. Hang up the furniture (Fig. C/C1/C2/C3)
٠ Mirrored cabinet or flat mirror (centre of the mirrored
cabinet = centre of the water supply connection)
٠ Tall cabinet, Upper cabinet, Centre cabinet
٠ Highboard
٠ Plug-in board
٠ Washstand base cabinet
(Mitte W TU = Mitte Wasseranschluss)
٠ Base cabinets
٠ Waschtisch
5. Aligning the cabinets (Fig. D/D1/D2/D3)
6. Mount washstand
For ceramic washstand:
٠ Put washstand in place, align, mount (Fig. D)
٠ Seal washstand (Fig. E1)
For top-fitted washstand:
٠ Sawing of cut-out for washstand (Fig. F)
٠ Attaching shelf for washstand (Fig. F1)
٠ Mounting of shelf (Fig. F2)
٠ Mount the cabinet and align
٠ Align the washstand and mark
٠ Remove the washstand and cabinet
٠ Mount the washstand (Fig. F3)
٠ Mount the cabinet
٠ Seal the washstand and cabinet (Fig. F4)
7. Install the tap (Fig. G)
٠ Warning: Use the enclosed rubber seal.
٠ Do not overtighten the tap!
8. Screw on the shelf (Fig. H)
٠ Warning: Do not drill through the shelf!
٠ Use the enclosed screws.
9. Mount Plug-in board (Fig. I)
10. Mount the doors and drawers (Fig. J/J1)
11. Aligning the doors (Fig. K/K1/K2)
12. Adjusting the drawer (Fig. L/L1/L2)
Important: Release the existing angle bracket!
13. Glue handles onto the door of the mirrored cabinet (Fig. M)
14. Adjusting the folding hinge (Fig. N)
15. Mount the rollers (Fig. O)
5