MA grandMA3 onPC rack-unit Kurzanleitung Seite 16

Turn on the onPC rack-unit
1. Unpack the grandMA3 device.
2. Remove the packaging and cushioning material.
3. Place the device indoors on a stable surface or install it in a 19" rack.
4. Connect external monitors to the grandMA3 device using the native DisplayPort connectors.
5. Connect an external mouse or keyboard using the USB ports.
6. Insert the IEC connector into the corresponding jack.
7. Connect the power plug.
8. Turn on the power switch on the rear panel.
9. Press the power key on the front panel.
Turn off the grandMA3 onPC rack-unit
Important:
Do not press the power key to turn off the device. Only if a hard shutdown is necessary, press and hold the power key for
more than 3 seconds.
1. Tap at the top of the control bar to start the shutdown procedure or shutdown the onPC software by the shutdown
keyword.
A warning pop-up appears:
Tap OK .
16
Intended Use
Safety
Support
Transport
Limitations
Quick Start
Maintenance
Disposal
Technical Data
Conformity