Unitec OBD II Gebrauchsanweisung Seite 23

20996_Bed.:Layout 1
Operating instructions
GB
"YES" -- all the monitors supported by the vehicle have completed their diagnostic tests and the
MIL does not light up.
"NEIN" -- at least one supported monitor on the vehicle has not yet completed its diagnostic test
and (or) the MIL "Check engine" lights up.
"READY" -- shows that a specific tested monitor has completed its diagnostic test.
"NOT READY" -- shows that a specific tested monitor has not yet completed its diagnostic test.
„N/C" -- the monitor is not supported in this vehicle.
„→" -- A flashing right arrow shows that additional information is available on the next screen.
„←" -- A flashing left arrow shows that additional information is available on the previous screen.
1) Select "3 I/M" from the main menu by pressing the OK/ENTER button.
• If the scan tool is not connected refer to "Reading codes" Points 1 to 6 in Paragraph 4.1.
2) Use the SCROLL button to display the status of the MIL lights ("ON" or "OFF") and the following
monitors:
MISFIRE -- Misfire monitor
FUEL -- Fuel system monitor
CCM -- Comprehensive components monitor
EGR -- Exhaust gas recirculation monitor
O2S -- O2 sensors monitor
Cat -- Catalyst monitor
EVAP -- Evaporative system monitor
HO2S -- O2 sensor heating monitor
2AIR -- Secondary air injection monitor
HCM -- Heated catalyst monitor
A/C -- A/C system monitor
3) Press the OK/ENTER button to return to the main menu.
14.04.2010 15:33 Uhr
Menu:
3. I/M
Seite 23
23