Intended Use - aquanique WP 10000 Gebrauchsanleitung

Product Description
Overview
 A Description
1 Handle, for lifting and carrying the pump
2 Stepped hose adapter, for connecting a hose with an inside diameter of 25 mm, 32 mm or 38 mm
3 Connection, pressure side, G1½
4 Pump base
5 Float switch, switches the pump on or off depending on the water level
6 Power connection cable
Symbols on the unit

Intended use

Only use the product described in this manual as follows:
• For pumping clear water or rain water.
• Pumping of soiled water and particles up to the permissible grain size. (→ Technical data)
• For irrigating and watering.
• For transferring water from and draining basins or ponds/pools.
• Extraction of water from a well.
– Only for irrigation and watering purposes!
• For pumping the water out of water butts/rain barrels or cisterns.
• Operate in accordance with instructions. (→ Technical data)
Possible incorrect use
The following restrictions apply to the unit:
• Not suitable for salt water.
• Not suitable for drinking water.
• Do not use for long-term operation (e.g. continuous recirculation of the water in a pond).
• Do not use for commercial or industrial purposes.
• Do not use in conjunction with chemicals, foodstuff, easily flammable or explosive substances.
• Do not connect to the drinking water supply.
Installation and connection
Connecting the pressure hose
An optimum flow rate is achieved with a hose inside diameter of 38 mm (1½").
How to proceed:
 B
1. Adapt the stepped hose adapter to the hose diameter
2. Screw the stepped hose adapter onto the connection on the pressure side.
3. Connect the pressure hose to the stepped hose adapter.
– Secure the pressure hose with a hose clip.
Watertight to 7 m depth.
Do not dispose of with normal household waste.
Read and adhere to the instructions for use.
- EN -
11