Introduction; Safety; Intended Use - Mettler Toledo easyFit 21 Bedienungsanleitung

easyFit
1
2
2.1
2.2
© 06 / 2021 METTLER TOLEDO
Printed in Switzerland

Introduction

– The insertion housing easyFit is safe to operate and has been tested by METTLER TOLEDO and
dispatched ready for in stallation.
– Before starting to use the housing, care fully read this Instruction Manual: the safety precautions
and warnings con tained in it must be observed.
In addition to this Instruction Manual please also note the following:
– All local safety regulations.
– All instructions and warning remarks in the publications of the products that are used in con-
junction with the insertion housing (electrodes, sensors, etc.).

Safety

Introduction
The Instruction Manual contains the most important information for using the easyFit housings
efficiently and in accordance with regulations. A basic condition for safe handling and operation
without malfunctions is the knowledge of these safety instructions and the observance of the fur-
ther warnings in the Instruction Manual.
This Instruction Manual, and in particular the safety regulations, are intended for personnel en-
trusted with the operation and maintenance of the housings. It is assumed that these persons
are familiar with the equipment in which the housing is installed. Therefore, before any work is
started with the housing, this Instruction Manual must be read and understood by those persons
involved.
The Instruction Manual must be stored where it is constantly accessible and available to any
person working with the easyFit housing.
On receipt of the shipment, check imme dia tely:
– The housing and accessories for any sign of transport damage. Report any damage immedi-
ately to the carrier and to your supplier.
– The type designation on the housing body.

Intended use

The insertion housings easyFit are intended solely for measurement tasks in conjunction with the
specified METTLER TOLEDO electrodes/sensors, namely pH and Redox (ORP) combination elec-
trodes as well as oxygen, and conductivity. Use the housings only for this purpose.
The following are also part of the stipulations for the correct and appropriate use of the housings:
– Compliance with the instructions, regu lations and information contained in this Instruction
Manual.
– Adherence to the prescribed inspection and maintenance/servicing intervals.
– Correct maintenance of the housings.
5
Insertion Housing easyFit
52 403 970 E