Assembly - Greencut GS200L Betriebsanleitung

62

ASSEMBLY

ASSEMBLY OF THE CHAIN AND THE SWORD
1. Release the chain brake by moving the front protector (3) backwards.
2. Unlock and release the bar locking device (7), then remove the chain sprocket protector (8).
3. Place the chain of the chainsaw (4) around the bar (5). Check the correct position in the groove of the bar.
Pay attention to the correct direction of rotation of the chain: the direction in which the arrow points on the
chain must match the direction marked on the bar.
ATTENTION: When placing the chain on the saw, observe the correct position of the guide groove
on the bar.
8
4. Keep the chain in the correct position on the bar and place the chain around the gear (chain wheel). Fit the
bar flush with the mounting surface so that the turn of the chain pin fits into the long groove of the bar.
5. Fit the chain sprocket guard (8).
6. Gently press the bar lock (7) in a clockwise direction.
CHAIN TENSION ADJUSTMENT
ATTENTION: During operation, re-tension the saw chain and bar after a maximum of 5 cuts.
1. Raise the tip of the sword slightly.
2. Check if the chain of the chainsaw works well by turning it manually.
3. Turn the tensioning knob (6) clockwise until the chain is attached to the
bottom of the bar.
4. Tighten and lock the locking device on the bar.
3
7
Sprocket of Sword Slot
the chain
8 6