ABNOX AXTR Serie Betriebsanleitung Seite 79

0010456_A1
7.4 Factory Configured Standard Parameters
Hardware:
Optional slot 1:
Optional slot 2:
Analog Input:
Temperature unit
Temperature unit (Unit):
Analog input 1
Sensor (SEnS):
Measured value correction (OFFS):
Filter time constant (dF):
Controller:
Controller type (CtYP):
Control direction (CACt):
Manual output level (HAnd):
Output level for Out of Range (rOut):
Desired value limit, start (SPL):
Desired value limit, end (SPH):
Manual operation (InHA):
Self-optimization:
Controller Parameters:
Proportional range 1 (Pb1):
Derivate time (dt):
Reset time (rt):
Cycle time 1 (CY1):
Switch differential 1 (HYS1):
Operating point (Y0):
Output level limit max (Y1):
Output level limit min (Y2):
Desired Values:
Desired value (SP1)
Desired value (SP2)
Ramp Function / Firing Curve:
Function (FnCt):
Limit Value Monitoring:
Limit value monitoring 1
Alarm function (FnCt):
Symmetry of limit value (ACrA):
Limit value (AL):
Limit value 2 (AL2):
Switch differential (HYSt):
Behavior for Out of Range (ACrA):
Alarm function – actual value (AFPr):
Alarm function – desired value (AFSP):
Turn-on delay (tOn):
Limit value monitoring 2
Alarm function (FnCt):
Symmetry of limit value (ACrA):
Limit value (AL):
Limit value 2 (AL2):
Switch differential (HYSt):
Behavior for Out of Range (ACrA):
ABNOX Temperature Controller AXTR-xxxxxx-xxxxx
Logic output
Relay (make contact)
[°C]
PT100 2-wire
0.000 [°C]
0.6 [s]
Two-point controller
Inverse
101 [%]
0 [%]
0.000 [°C]
100.0 [°C]
Free
Free
3.500
3.000 [s]
13.000 [s]
2.0 [s]
1.000
0 [%]
100 [%]
-100 [%]
60.00
60.00
Turned off
Alarm function 3
Symmetrical
1.000
61.00
1.000
Alarm function on
Analog input 1
Current desired value
0 s
Alarm function 5
Symmetrical
1.000
61.00
1.000
Alarm function on
Page 79 of 84