Connecting To A Dj Mixer; Connecting With A Computer; Place Of Installation; Adjusting The Height Of The Main Unit - PIONEER DJ PLX-500-K Bedienungsanleitung

Connecting to a DJ mixer

Audio cable
Turntable
2
1 Set the [PHONO/LINE] switch to [PHONO].
2 Connect the audio cable to the [PHONO] input terminal of the DJ mixer.
! If this product is connected to a DJ mixer that does not have a [PHONO] input terminal, sufficient volume and sound quality cannot be obtained. In
that case, set the [PHONO/LINE] switch of this unit to [LINE] and then connect the unit to the [LINE] input terminal of the DJ mixer.
3 Connect the power cord.
Connects to a power outlet using the included power cord. Wait until all connections between the equipment are completed before connecting the
power cord.

Connecting with a computer

USB driver software is not required for this unit.
= Recording (p. 15 )
Computer
1 Connect the USB cable to a USB port on the computer.
2 Connect the power cord.
Connects to a power outlet using the included power cord. Wait until all connections between the equipment are completed before connecting the
power cord.

Place of installation

Place the unit on a level surface that is free of external vibration.
! To the extent possible, keep the unit away from the speaker system.
! When the unit is very close to a radio (AM/FM broadcasting), the
radio could generate noise. Keep the distance as far away from the
unit as possible.
DJ Mixer
Audio cable
USB cable
1
Power cord
1
Adjusting the height of the main
unit
Adjust the height by turning the insulator in a way that the main unit is
horizontal.
Rear panel
3
To power outlet
Rear panel
2
Power cord
To power outlet
13
En