Configuration And Operation; Cleaning And Maintenance - Sonia IZAR Bedienungsanleitung

CONFIGURATION AND OPERATION

● Connect the power cable to the mains.
- The water level inside the tank must stand between the
"MIN" and "MAX" levels.
- Press
on the control panel and the power indicator
lights up blue. The unit remains in standby mode and
the control panel shows the following configuration:
• The timer will show 15 minutes.
• The steam volume indicator shows the maximum level.
• The ozone function indicator is off.
• The heating and steam indicators
• Press the button to switch between the standby
mode and the heating and steaming functions.
- If the indicator lights up red, the heating function
is active. The timer will show 30 min by default and
start counting down.
Once the heating temperature has been reached, it
will be maintained until the timer reaches 0.
• If the indicator lights up green, the steaming
function is active. The timer will show 15 min by default
and start counting down.
After a few minutes, steam will start to come out of the
arm head nozzle.
• Set the timer using the
the operating time of the different functions.
- The heating function
range.
- The steaming function
range.
This function allows defining the operating time for
both functions: heating and steaming.
• Use the "ENERGY" button to adjust the steam volume
to be produced by the nozzle
- If the indicator lights up in full, the steam volume is
at maximum level.
- If the indicator lights up in half, the steam volume
is at half level.
- If only one line of the indicator
volume is at the minimum level.
• Activate the Ozone function by pressing the "OZONE"
button. The ozone function indicator will light up
green. Press again to deactivate the function and the
indicator will turn off.
Bear in mind:
• The heating function is a heat conservation function.
• If, before activating the steaming function, the heating
function has been activated, the steam is produced
faster compared to a direct steaming function
activation.
• The ozone function indicator will only light up green
when the steam function has been selected.
• If the timer shows "E2" when using the heating or
steaming functions, the "WARNING" indicator flashes
and an acoustic signal sounds, this indicates that the
water level is too high. The active function will stop
are off.
or buttons to establish
allows a 1 to 90-minute
allows a 1 to 30-minute
lights up, the steam
immediately.
Any locked functions will be unlocked as the water
level returns between "MAX" and "MIN". Press
resume operation.
• If the timer shows "E1" when using the heating or
steaming functions, the "WARNING" indicator flashes
and an acoustic signal sounds, this indicates that the
water level is too low. The active function will stop
immediately.
Fill with distilled water to unlock functions and resume
operation.
• If you need to change the essential oil, remove the
cotton by opening the sliding lid at the top of the arm
head nozzle, use tweezers to remove the cotton and
replace it with a new one. Add oil as required.
• Adjust the sound volume of the acoustic signals of
the steamer: with the unit turned off, press and hold
the "ENERGY" button until the timer reads "5". This is
the default sound volume, which you can adjust using
or from 0 to 9, where 0 is the min. volume and
9 the max. volume. As you do so, the selected value
flashes and is saved automatically.

CLEANING AND MAINTENANCE

● Before cleaning the device, unplug it from the mains.
● Clean the device with a soft, dry cloth. Do not use liquids
to clean it.
● Despite recommending the use of distilled water to
prevent calcification of the elements, it is advisable to
regularly clean the heating resistor and the level sensors
in order to guarantee the correct operation of the steamer
and prevent the appearance of possible error messages.
To do so, fill up the water tank with vinegar and leave it
in place for about 10-15 minutes, making sure that the
resistor and sensors are covered by the vinegar. Then rinse
as many times as necessary with plenty of water until all
the vinegar and its smell have gone.
● For maintenance or repairs of any part of the product,
please contact your distributor or specialised technician.
RECYCLING
If you need to dispose of the product or any of its parts
or accessories, please check and respect the laws
and regulations applicable to waste management and
environmental protection.
to
EN
5