Control Panel - Sonia IZAR Bedienungsanleitung

- Step
3 : Insert the "conical part" at the bottom of the
"extendable column". Then place everything onto the
"base for the 5 feet" and press down until properly
fitted.
Finish this step by screwing in the "base clamping
plate" with the "attachment kit".
- Step : Place the "main unit" onto the "column anchor
4
bracket" to complete assembly.
- To install or remove the water tank, disconnect the
steamer from the mains. If it has been used recently,
wait for the water to cool down before removing it.
- To insert the tank, hold it with one hand and turn it in
an anticlockwise direction while keeping hold of the
bottom. To remove it, follow the same procedure but
turn in a clockwise direction.
- Make sure the tank is properly centred before tightening
the knob again.
● Set-up
- Fill the water tank by opening the steamer filler cap
and pouring in distilled water. The water level must
remain between the "MIN" and "MAX" lines. Once filled,
replace the cap.
- Add essential oils by opening the sliding lid at the top of
the arm head nozzle and dropping one or two oil drops
onto the cotton.
EN
4
- Never add essential oils directly into the water tank.
- Unlock the steamer arm (the arm is locked as you
remove the steamer from the box). Following the arrows
in the image, pull out the pin to unlock the arm and
turn it upwards to finish unlocking. The arm should turn
freely, allowing a 130º rotation angle.
- The steamer arm can be adjusted 130º either to the left
or to the right.
- The steam outlet on the steamer arm can be adjusted
60º forwards and backwards, and can be rotated 360º.

CONTROL PANEL

1 2 3 4 5 6 7 8 9
Water-level warning indicator
1
Ozone function indicator
2
Ozone function on/off button
3
Decrease time button
4
Power on indicator
5
On / off button
6
7 Heating indicator
Heating/Steaming button
8
Steaming indicator
9
Increase time button
10
Timer
11
Steam volume adjustment button
12
Steam volume indicator
13
10 11 12 13