NGS FORTRESS BUNKER Handbuch Seite 4

USER'S MANUAL
INSTALLATION AND OPERATION
Installation for Standard UPS
1. Shut down the load (for example PC), pull out power gird.
2. Put UPS on the proper position (following the manual).
3. Connect the charging device (for example, the PC) to the UPS in a
protected output.
4. Put the plug to the AC power socket (make sure GND is
connected well).
Input
Outputs with
protection against
power surges
4
5. Connect to AC: press the panel switch turning on the UPS,
the green LED and yellow LED light, then you can turn on your
computer etc.
6. Battery mode: press the panel switch turning on the UPS, the red
LED lights.
7. Normally turning UPS: press the panel switch turning on the UPS.
8. Normally turning off UPS: press the panel switch turning off the
UPS.
Outputs protected
by battery