General Maintenance - GreenWorks GDC60 Bedienungsanleitung

EN
DE ES IT FR PT NL RU FI SV NO DA PL CS SK SV HR HU RO BG EL AR TR HE LT LV ET
USING THE GUN (See Figure 8.)
For greater control and safety, keep both hands on the
gun at all times.
„ Squeeze the trigger (15) to operate the pressure
washer.
„ Release the trigger to stop the flow of water through
the nozzle.
To engage the lock-out:
„ Press the lock-out button (16) to the ON position.
To disengage the lock-out:
„ Press the lock-out button to the OFF position.
USING THE NOZZLES (See Figure 9.)
NEVER change nozzles without engaging the
lock out on the gun and NEVER point the lance
at your face or at others.
To connect a nozzle to the lance:
„ Turn off the pressure washer. Pull trigger to release
water pressure.
„ Engage the lock out on the gun by pulling down on
the lock out until it clicks into the slot.
„ Press the button on the lance and insert the nozzle,
aligning the pin on the nozzle with the hole.
„ Rotate the nozzle to adjust the spray shape.
ADDING DETERGENT
WASHER (See Figure 10-11.)
Use only detergents designed for pressure washers;
household detergents, acids, alkalines, bleaches, sol-
vents, flammable material, or industrial grade solutions
can damage the pump. Many detergents may require
mixing prior to use.
Prepare cleaning solution as instructed on the solution
bottle.
NOTE: Use a funnel, if needed, to prevent accidental
spilling of the detergent outside the tank. If any
detergent is spilled during the filling process, make sure
the unit is cleaned and dried before proceeding.
To apply soap:
„ Pour detergent in the detergent tank.
„ Install the soap tank to the trigger gun.
„ Start the pressure washer and spray the detergent
on a dry surface using long, even, overlapping
strokes. To prevent streaking, do not allow
detergent to dry on the surface.
English (Original instructions)
CAUTION
TO THE PRESSURE
STARTING AND STOPPING THE PRESSURE
WASHER (See Figure 12.)
Do not run the pump without the water in the bucket
connected and turned on.
„ Add the water into the bucket.
„ Install the bucket and lock it out.
„ Install the battery pack.
„ Set the switch to the ON position to start the motor.
„ Turn the garden hose on then squeeze the high
pressure trigger.
MAINTENANCE
When servicing, use only identical replacement
parts. Use of any other parts may create a hazard or
cause product damage.
Before inspecting, cleaning, or servicing the ma-
chine, shut off motor, wait for all moving parts to stop,
and remove the battery pack. Failure to follow these
instructions can result in serious personal injury or
property damage.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
Do not at any time let brake fluids, petrol, petro-
leum based products, penetrating oils, etc., come in
contact with plastic parts. Chemicals can damage,
weaken or destroy plastic which may result in seri-
ous personal injury. Only the parts shown on the
parts list are intended to be repaired or replaced by
the customer. All other parts should be replaced at
an authorized service centre.
4
CAUTION
WARNING
WARNING
WARNING