Beper P202VAL110 Bedienungsanleitung Seite 7

Product description Fig.A
1. Spraying nozzle
2. ON/OFF switch
3. Water tank
4. USB cable
Charging of the appliance
The appliance can be charged with the USB cable include din its box. Insert the cable
in the connection hole found on the appliance, and connect it to a wall socket using
a USB adapter (not included).
Once the appliance has been connected to the wall socket, ON/OFF switch will light
up red; once charging is completed, the ON/OFF switch will turn green, and the ap-
pliance is ready to be used.
Once charging is done, remove the USB cable from the appliance.
Use of the appliance
Remove the water tank by rotating it clockwise. Fill it with the solution to be sprayed,
paying attention not to exceed the 120 ml line marked on the tank. Put the tank back
in place and tighten it by rotating it counterclockwise.
Warning: do not use emulsions, creams, pure essential oils or other sub-
stances with a viscosity equal to or higher than 2000 mPas, to avoid clog-
ging the spraying nozzle. Check technical and/or safety sheet of the solution
before use.
By pressing the ON/OFF switch, this will light up blue, and the appliance starts ope-
rating. Spray the surface to be treated, adjusting the spraying length based on your
needs.
Press ON/OFF switch again to turn the appliance off.
Once done using the appliance, empty out the tank, rinse it under running water, and
let dry completely.
Cleaning and maintenance
Before carrying out any cleaning or maintenance operation, make sure that the ap-
pliance is off and the USB cable is disconnected.
To ensure deep cleaning and optimal operation of the appliance, after each use it is
advisable to fill the tank with water, and to let the appliance run until the tank is empty:
this way, any residue left by the solutions used will be removed, and it will be possible
to use the appliance with other substances.
If the spraying mist is not regular or with a strongly decreased intensity than usual, it
is advisable to clean the spraying nozzle with a needle or other sharp pointed object,
paying attention not to get hurt.
If by mistake, a very thick solution with a viscosity higher than 2000 mPas has been
used, and the spraying nozzle is clogged, fill the tank with warm water (40°C-50°C),
and spray until the spraying nozzle is clean.
Warning: do not immerse the appliance in water or other liquids.
If necessary, clean the outer surface with a soft, slightly dampened cloth, and dry
thoroughly.
Before storing the appliance, empty the tank, rinse it under running water and dry it
thoroughly.
7
EN